Skip to main content

 

 

Cisco Defense Orchestrator

ASA Configuration using CLI

You can configure an ASA device by running the CLI commands in the CLI interface provided in CDO. To use the interface, on the Devices & Services menu, select the device and click Command Line Interface. For more information, see Using the CDO Command Line Interface.

Add a New Logging Server

System logging is a method of collecting messages from devices to a server running a syslog daemon. Logging to a central syslog server helps in aggregation of logs and alerts.

For more information, see CLI Book1: Cisco ASA Series General Operations CLI Configuration Guide for the versions of ASA you are running. 
In the 'Monitoring' section, see the 'Logging' chapter.

Configure the DNS Server

You need to configure DNS servers so that the ASA can resolve host names to IP addresses. You also must configure DNS servers to use fully qualified domain names (FQDN) network objects in access rules.

For more information, see CLI Book1: Cisco ASA Series General Operations CLI Configuration Guide. In the 'Configure the DNS Server' section, see the 'Basic Settings' chapter.

Add Static and Default Routes

To route traffic to a non-connected host or network, you must define a route to the host or network, either using static or dynamic routing.

For more information, see the 'Static and Default Routes' chapter of CLI Book1: Cisco ASA Series General Operations CLI Configuration Guide.

Configure Interfaces

You can configure the management and data interfaces using CLI commands. For more information, see the 'Basic Interface Configuration' chapter of CLI Book1: Cisco ASA Series General Operations CLI Configuration Guide.

  • Was this article helpful?