Skip to main content

 

 

Cisco Defense Orchestrator

Edit or Remove a Subinterface from an EtherChannel

Use the following procedures to either modify an existing subinterface, or remove a subinterface from an Etherchannel interface.

Note: Subinterfaces and EtherChannel interfaces have a series of guidelines and limitations that may affect your configuration. See the general subinterface limitations for more information.

Edit a Subinterface

Use the following procedure to edit an existing subinterface associated with an EtherChannel interface:

  1. Log into CDO. 
  2. In the navigation pane, click Devices & Services
  3. Select the FTD associated with the EtherChannel and subinterface you want to edit. In the Management pane located to the right, select Interfaces
  4. Locate and expand the Etherchannel interface that the subinterface is a member of.
  5. Select the desired subinterface you want to edit. In the Action pane located to the right, click the edit icon edit.png .
  6. Modify any of the following items:
  • Logical name.
  • State.
  • Description.
  • Security Zone assignment.
  • VLAN ID
  • IP address configuration in either the IPv4, IPv6, or Advanced tabs.
  1. Click Save

Remove a Subinterface from an EtherChannel

Use the following procedure to remove an existing subinterface from an EtherChannel interface:

  1. Log into CDO. 
  2. In the navigation pane, click Devices & Services
  3. Select the FTD associated with the EtherChannel and subinterface you want to edit. In the Management pane located to the right, select Interfaces
  4. Locate and expand the Etherchannel interface that the subinterface is a member of.
  5. Select the desired subinterface you want to delete.
  6. In the Actions pane located to the right, click Remove
  7. Confirm you want to delete the subinterface interface and click OK.

 

Related Articles:

  • Was this article helpful?