SDC Status Does not Become Active on CDO after Deployment

If CDO does not indicate that your SDC is active in about 10 minutes after deployment, connect to the SDC VM using SSH using the cdo user and password you created when you deployed the SDC.

Procedure

Step 1

Review /opt/cdo/configure.log. It shows you the configuration settings you entered for the SDC and if they were applied successfully. If there were any failures in the setup process or if the values weren't entered correctly, run the sdc-onboard setup again:

  1. At the [cdo@localhost cdo]$ prompt entersudo sdc-onboard setup.

  2. Enter the password for the cdouser.

  3. Follow the prompts. The setup script guides you through all the configuration steps you took in the setup wizard and gives you an opportunity to make changes to the values you entered.

Step 2

If after reviewing the log and running sudo sdc-onboard setup, CDO still does not indicate that the SDC is Active, contact CDO support.