Enable or Disable an Interface
You can change the Admin State of each interface to be enabled or disabled. By default, physical interfaces are disabled. For VLAN subinterfaces, the admin state is inherited from the parent interface.
Procedure
Step 1 | Choose Interfaces to open the Interfaces page. The Interfaces page shows a visual representation of the currently installed interfaces at the top of the page and provides a listing of the installed interfaces in the table below. |
Step 2 | To enable the interface, click the disabled Slider
disabled ( Click Yes to confirm the change. The corresponding interface in the visual representation changes from gray to green. |
Step 3 | To disable the interface, click the enabled Slider enabled
( Click Yes to confirm the change. The corresponding interface in the visual representation changes from green to gray. |
)
)