Limitations for Migration

The wizard does not migrate:

• Site-to-site VPN policies

• SNMP configurations

  After the migration, you can configure SNMP using the platform settings for the device.

You can perform only one migration at a time.

If the speed, auto-negotiation, and duplex settings of the source interface are valid for the mapped interface of the target device, the values are copied. If not, these parameters are set to the default values.

Remote access VPN trustpoint certificates are not enrolled. You must manually enroll these certificates before the deployment.

After migration, by default, the target device uses Snort 3 and not Snort 2, even if the source device uses Snort 2.

For HA devices:

• Target Device: You cannot map the interfaces that are part of the failover configuration. These interfaces are disabled in the wizard.

• Source and Target Devices: The wizard does not migrate HA configurations such as monitored interfaces, failover trigger criteria, and interface MAC addresses. You must manually configure these parameters after the migration if required.