Review Conflict Procedure

To review configuration changes from the FDM-managed device, follow this procedure:

Procedure


Step 1

In the navigation bar, click Inventory.

Step 2

Click the Devices tab.

Step 3

Click the appropriate device type tab.

Step 4

Select the device whose configuration is marked Conflict Detected and gives you a link to Review Conflict in the Conflict Detected pane on the right.

Step 5

Click Review Conflict.

Step 6

Compare the two configurations presented to you.

Step 7

Take one of these actions:

  • Click Accept to overwrite the last known configuration on CDO with the one found on the device. Note: The entire configuration stored on CDO will be completely overwritten by the configuration found on the device.

  • Click Reject to reject the changes made on the device and replace them with the last known configuration on CDO.

  • Click Cancel to stop the action.

Note

You can prompt CDO to immediately check a device for an out-of-band change by clicking Check for Changes while the device is in the Synced state.